Current mass spectrometry strategies for selenium speciation in dietary sources of high-selenium

This document reviews the most relevant mass spectrometry approaches to selenium (Se) speciation in high-Se food supplements in terms of qualitative and quantitative Se speciation and Se-containing species identification, with special reference to high-Se yeast, garlic, onions and Brazil nuts. Important topics such as complexity of Se speciation in these materials and the importance of combining Se-specific detection and molecule-specific determination of the particular species of this element in parallel with chromatography, to understand their nutritional role and cancer preventive properties are critically discussed throughout. The versatility and potential of mass spectrometric detection in this field are clearly demonstrated. Although great advances have been achieved, further developments are required, especially if speciatedcertified reference materials (CRMs) are to be produced for validation of measurements of target Se-containing species in Se-food supplements.     

Influence of drawing and heat treatment on surface free energies of polyethylene terephthalate fibers

The surface free energies of polyethylene terepthalate fibers with different draw ratios were experimentally determined by contact angle measurements inn-alkane/water systems. The dispersive component of the surface free energy increased with increasing draw ratio, whereas the nondispersive one remained almost constant. After heat treatment, the dispersive surface free energy increased, but was reduced above 140°C. The nondispersive component increased by heat treatment at 190°C. The increases in the density and birefringence of the fibres due to the drawing and heat treatment suggested that the increase in the dispersive surface free energy was caused by the increase in the atomic density at the fiber surface due to drawing and heat treatment. ESCA results indicated that the increment in the nondispersive surface free energy due to heat treatment was caused by the addition of functional groups to the fiber surface due to heat treatment.     

Second-order nonlinear optical properties of side-chain liquid crystalline polymers studied by second harmonic generation from thin films

The two independent elements of the second-order nonlinear optical susceptibility tensor of a range of contact poled, donor–acceptor substitued side-chain polymers are reported. The susceptibilities were measured by second harmonic generation from thin films, typically less than 0.5 μm thick, at a fundamental wavelength of 1064 nm. The largest value was χ = 2.64 pm/V which is three times greater than the χ value of KDP and was measured in a nitrobenzylidene side chain, polyhydroxystyrene polymer with an eleven unit alkyl chain spacer attaching the side group to the backbone. Typical susceptibility values obtained were χ～0.3 pm/V and X⁽²⁾₃₃～1 pm/V. The coherence lengths of the materials, which lay in the range 4–12 μm, were measured at 1064 nm by the maker fringe technique using thick, wedge-shaped samples.     

Loss and recovery in hydrophobicity of silicone rubber exposed to corona discharge

This paper describes the loss and recovery in the hydrophobicity of unfilled high temperature vulcanized silicone rubber (HTV-SR) resulting from corona discharge. In this study, HTV-SR specimens were exposed to corona stress generated by a parallel needle-plane electrode system, and physicochemical analyses on the surface layer of SR before and after corona discharge treatment were carried out by using Fourier transform infra-red (FTIR) spectroscopy, scanning electron microscopy (SEM) and X-ray photoelectron spectroscopy (XPS). It is demonstrated that hydrophilic OH groups that are by-products of ageing can be formed instead of hydrophobic CH₃ groups on the surface of aged SR and the corona discharge plays an important role on the temporary loss of hydrophobicity. After a substantial period of ‘rest’, the hydrophobic recovery of SR results from the diffusion of low-molecular weight (LMW) silicone fluid from the bulk onto the aged layer.     

液相色谱串联质谱法(LC-MS/MS)分析宠物食品中三聚氰胺

三聚氰胺(melamine)为白色或无色结晶,通常用于塑料制品中合成树脂的生产中,高温和酸性条件下能引起三聚氰胺转移到食品中.三嗪类农药环丙氨嗪(cyromazine)在极端的pH条件下或者光降解的条件下也能生成三聚氰胺.     

高抗冲聚苯乙烯的增韧机理

概述了以高抗冲聚苯乙烯（ＨＩＰＳ）为中心的有关橡胶增韧机理的理论，并且总结了界面，性能、粒子尺寸、粒 距及缠结密度等因素对橡胶／高分子共混体系性能的影响。     

Dependence of mechanical and aging properties of chloroprene rubber on silica and ethylene thiourea loadings

The interaction between precipitated silica and chloroprene rubber (CR) was investigated using a nuclear magnetic resonance (NMR) technique. The results reveal that the silanol groups on silica surface could chemically react with CR. Crosslinking of CR is therefore possible in the presence of silica at high temperature. The effects of silica and ethylene thiourea (ETU) loadings on properties of the silica-filled CR were thereafter investigated. With increasing silica loading, the compound viscosity increases considerably due to the dilution effect. As silica could act as a curative for CR, increasing silica loading results in both faster cure rate and increased crosslink density. The optimum tensile strength is found at approximately 30 phr of silica loading. The results also show that silica loading has little effect on most aging properties, except the relative modulus in which it increases rapidly with increasing silica loading due to the post curing effect. Similar to the effect of silica loading, the compound viscosity, cure rate and crosslink density are all increased with increasing ETU loading. The tensile strength is, on the other hand, slightly affected by ETU loading. Exception is found at high loading where the tensile strength drops noticeably. Interestingly, aging resistance of the vulcanizate is found to improve with the addition of ETU. Explanation is given by the hindrance capability of ETU to post curing.     

Determination of aristolochic acid by capillary zone electrophoresis

A simple and rapid capillary zone electrophoresis (CZE) method for the determination of aristolochic acid (AA) in dietary supplements and selected herbs is described. A clear separation of AA from other sample constituents was achieved within 5 minutes without any sample clean up. A mixture of 20 mM-morpholinethanesulphonic acid+10 mM-BisTrisPropane+0.2% hydroxyethylcelullose in 10% methanol serves as a background electrolyte. The linearity, accuracy, intra-assay and detection limit of the developed method are 200–6000 ng/mL, 95–103%, 3.5%, and 50 ng/ml, respectively. Ease of use, sufficient sensitivity and low running cost are the most important attributes of the CZE method. The proposed CZE method was compared with HPLC.     

Morphology of peroxide-prevulcanised natural rubber latex: effect of reaction time and deproteinisation

A non-uniform mesh structure, i.e. a dense network near the surface of peroxide-prevulcanised natural rubber latex particles, was observed under transmission electron microscopy. In the initial period of prevulcanisation, the swelling ratio of the latex sheet decreased with longer reaction time while an increase in crosslink density of rubber particles containing polystyrene, prepared using the phase transfer/bulk polymerisation process, was noticed. The modulus of the rubber sheet increased up to maximum crosslinking and thereafter decreased. After removal of proteins from the latex membrane layer, derived from protein-lipid originally existing at the rubber particle surface, could not be detected. The absence of proteins, which act as free radical scavengers, resulted in a rapid diffusion of alkoxy radicals into the rubber phase of deproteinised latex and, therefore, a uniform crosslink distribution inside each particle was obtained.     

Theoretical Study on the Dark Oxidation Reaction Mechanism of Ethers

1 INTRODUCTION Ethers are a kind of organic compounds that are easily oxidized under the conditions of lacking light and any additional excitement. According to dif- ferent mechanisms, the oxidation reactions could be classified into two types: photooxidation reaction and dark oxidation reaction. The former is the reaction with excited state oxygen molecule (singlet state), while the latter is the reaction with ground state oxygen molecule (triple state) without illuminance or any exciter…